價格、規格詳情請咨詢客服再下單

  产 品 规 格  

product specification

因测量工具、手法的不同，测量尺寸可能会有1-2cm左右的误差，敬请谅解！

because measurement method and tool not the same, the size will be have a little difference.

  产 品 图 片  

product picture

材 质 与 保 养  

Material and maintenance

珐琅锅注意事项：

1、首次使用本品，用温水加中性洗剂仔细清洗即可使用。

2、日常使用中性或专用洗剂用品。

3、避免温度骤变，锅具温度高时，不易立即倒入冷水或将锅子放于冷水中，以防止珐琅层脱落。

4、避免加热过度。本产品有很好的导热性，高温加热会使锅体加热过度。建议使用中低火加热。

5、使用后请尽快擦拭干净，并置于通风处，不要长期放在潮湿处。

6、严禁过度磕碰，防止珐琅层损伤。

7、尽量使用木质或者硅胶锅铲，避免使用金属铲、钢丝球，以免刮伤珐琅，影响锅子使用寿命。

8、珐琅锅由于皆采用沙模铸成，当铁水倒入模具会产生大量气体，所以制成品可能会产生沙眼 气孔等情况。珐琅锅层采用倒置喷涂，所以锅口锅沿       有部份露出银灰色铁质，并非质量问题！清洗干净后可在锅口处涂抹植物油防锈处理。

9、造型锅的锅盖为复杂的非规则结构，在烧制的过程中会有不均匀的引力产生，导致锅身和锅盖之间有一定的缝隙属于正常情况，不影响使用，

     请放心。如果介意以上情况请慎重选择！

1. First time use this cookware, choose warm water add some Neutral detergent to clean.

2. In daily life use Neutral detergent or Dedicated detergent to clean, can keep cast iron cookware life long time.

3. Avoid sudden temperature changes, when the cookware high temperature, pls don’t put the cold water, prevent enamel      coating  fall off.

4. Avoid overheating, this cookware have thermal conductivity, high temperature heating will be make cookware body           overheat,It is     recommended to use low heat heat

5. Pls wipe up after use, put the well-ventilated area, if put the wet place not good for the cookware.

6. It is forbidden to excessive knock against，To prevent the enamel coating fall off。

7. You’d better use Wooden shovel or silicone shovel, Avoid using metal shovel and a steel ball, So as not to scratch the            enamel,Affect the service life.

8. Enamel cookware adopt stand mould make, when the iron water put into the mould will be happen a lot of pneumato, so the end  product will be have Trachoma stomatal. Enamel coating choose inversion spray, so the edge of the pan will be have some silver    gray irony. Pls note that this is not quality problem, when you clean the cookware, edge wipe vegetable oil to rust protection.

9. Special cookware cover also anomaly, in the produce have Uneven gravity is produced,result in body and cover have a little gap,this is normal circumstances, pls don’t worried.

 If you mind this imperfect, pls think carefully about buying.

  海 运 包 装 及 走 货 流 程  

 Shipping by sea and shipment process